LIGO SP – RS232 FUEl LEVEL SENSOR

LIGO SP – RS232 probe length: (700mm-6000mm)

General description 

LIGO SP – RS232 is a special improvement line, a product of the research team of Soji electronics fuel level sensor. Changes in the mechanical design help the sensor achieve high accuracy and durability.

  • Highly accuracy up to 99.5%.
  • Length allow cut off up to 80 % of the initial length of the measuring probe.
  • Automatic recognize new length after cutting feature (this feature can be enable or disable by software on PC).
  • Wide range working temperature from -40°C – +85°C.
  • Screen filter is mounted on the measuring probe tubes to protect measuring probe electrodes from mud and water.
  • IP67 waterproof.
  • Advanced filter algorithm and temperature compensate.
  • Configuration,update firmware through software on PC .
  • Easy to install and sealed.

SPECIFICATIONS:

Parameter Value
DC input voltage, V 9-37
Standard length  (L),mm 700, 1000, 1500…up to 6000 mm
Power consumption(W)

Typical

Maximal

At short circuit on analog output, maximum

0.24

0.4

1.6

Measuring period, s 1
Output interface for measured values RS-232, RS-485
Message interval, s 1…60
Averaging time, s from 0…120
Measuring error, % ±0,5
Baud rate, bit/sec 2400, 4800, 9600, 19200, 38400, 57600, 115200
Input current, mA Max 20
Working temperature, °C -45 to 105
Ingress protection rating, IP IP67
DAC resolution, bit 12
Working principle (Capacitive Sensor)
Average service life, years 8

SIZE: 

 

 

 

 

 

Download

Documentation 

     Datasheet AF, RS232 Fuel Level Sensor V2.4.1 (Vietnamese)

DISCLAIMER:

  • Do not expose the meter to direct contact with water.
  • Do not use the sensor with explosive solvents such as gasoline, alcohol, gas … manufacturers will not be responsible for compensation in the event of fire.
  • Sensors should be installed away from corrosive chemicals such as salts, alkalis, acids …